1. Home
  2. Products
  3. High Voltage Power Equipment
  4. Cable Distribution Box, American Type

Cable Distribution Box, American Type

 Cable Distribution Box, American Type
Product overview:

The American type cable distribution box does not have a switch and it is cabling engineering equipment widely used in power distribution network systems in North America. It has the following main features: single swing door, horizontal busbar, clear cable arrangement, full insulation, and full enclosure. The box can be divided into a 600A main circuit and 200A sub-circuit according to the rated current. The 600A main circuit connection is bolt fixed. The 200A sub-circuit is plug connected which can be matched with the load plug. The cable joint of the American type cable distribution box meets DIN47636 standards.

Application:

The American type cable distribution box is cabling engineering equipment widely used in power distribution network systems in North America.

Technical parameters:

-Rated voltage 12KV
-Rated current 690V
-1min power-frequency withstand voltage 42KV
-Thermal current 15-50KA
-Dynamic current 40-125KA
-Lighting impulse withstand voltage 75-105KV

Features:

-Full insulation, full enclosure, no insulation distance, full safeguard.
-American type cable distribution boxes are anti-dust, anti-flood, corrosion resistant, and maintenance-free. They can be used outdoors with
-In-out wire is flexible: there are at most 8 branches of in-out wire in application to match various wiring requirements.
-It is small in size, easy to install, and easy to operate.
-200A branch cable joint can be used as a load switch, which can plug with load, also has the functions of an isolation switch.
-It can be matched with the cable fault indicator, in order to find out the cable fault rapidly.

Application environment:

-Maximum Air Temperature: +40 ℃, minimum air temperature: -30 ℃
-Wind speed: 34m/s (less than 700 Pa)
-Relative humidity daily average value is no more than 95%
-Ground surface horizontal acceleration: Lower than 0.4 m/s2
-Ground surface vertical acceleration: Lower than 0.1m/s2
-Installation site inclination: ≤ 3 degrees
-The surrounding air should be free from corrosive and combustible gases, and there should be no severe vibration at the installation site.

Inquiry Form